Dennis Wake – Lincolnshire Woodturners

Great demonstration by the very knowledgeable Dennis Wake. Dennis did three pieces, an elephant made from several pieces, Christmas Tree with small LED candle inside and most impressive, offset turned goblet.

The offsetting was such a simple and effective idea, definitely going to give this a try in the future.

The goblet is turned in the normal axis then shifted slightly to allow an offset cut. I have seen this done before but it was so much more complicated, Dennis made it look easy.

Dennis also had a couple of tools I have never seen before. A round nylon tail stock pad that supported the piece without causing and damage.

He also has neoprene covered pins that replaced the jaws of the chuck. They were great, they came in three different sizes but were were quite expensive, I think I could make some of these.

Share this

Leave a Reply

Your email address will not be published. Required fields are marked *